Digilent 410-216P-KIT User Manual download pdf (Page 9)

chipKIT Basic I/O Shield Reference Manual

www.digilentinc.com page 9 of 15

Appendix B: Example Driver Code

The following gives an example of code to initialize the display controller and write the contents of a

memory buffer into the display. This example is written for the chipKIT Uno32 board.

Symbol and Variable Declarations

/* ------------------------------------------------------------ */

/* Pin definitions for access to OLED control signals on chipKIT Uno32

#define prtVddCtrl IOPORT_F

#define prtVbatCtrl IOPORT_F

#define prtDataCmd IOPORT_F

#define prtReset IOPORT_G

#define bitVddCtrl BIT_6

#define bitVbatCtrl BIT_5

#define bitDataCmd BIT_4

#define bitReset BIT_9

/* ------------------------------------------------------------ */

/* Symbols describing the geometry of the display.

#define cbOledDispMax 512 //max number of bytes in display buffer

#define ccolOledMax 128 //number of display columns

#define crowOledMax 32 //number of display rows

#define cpagOledMax 4 //number of display memory pages

/* ------------------------------------------------------------ */

/* This array is the off-screen frame buffer used for rendering.

** It isn't possible to read back from the OLED display device,

** so display data is rendered into this off-screen buffer and then

** copied to the display.

BYTE rgbOledBmp[cbOledDispMax];

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Digilent 410-216P-KIT User Manual Page 9